ZLT S10G V2.10.1 Open Line with Open APN Access


DISCLAIMER:
This tutorial is compatible only for ZLT S10GV2.10.1 version. Do not proceed if the version is not compatible otherwise it will brick your modem.
Downloadable link 1: ZLTS10GV2.10.1 No Virus
Downloadable link 2: ZLTS10GV2.10.1 No Virus

password: gensh123

NOTE: 
Make sure to backup your original IMEI modem number before proceeding


Free IMEI List: FREE IMEI

LETS START!

  • Unang gagawin: Dapat may load ng sim na ilgay sa ZLTS10Gv2.10.1

  • Next open Network and internet settings, then click change adapter options
IMPORTANT:
click “Ethernet” kung ikaw ay naka LAN cable at “wifi” naman kung ikaw
ay naka wireless connection
  • Next right click “Ethernet” (for LAN) or “wifi” (for wireless) then select properties and double click “Internet Protocol Version 4 (TCP/IPV4) and click “Use the following IP address” input the following in the box:
  1. 192.168.254.5
  2. 255.255.255.0
  3. 192.168.254.254




  • Open firefox, go to dashboard’s gateway address 192.168.254.254 then login: 
USER: user
PASSWORD: @l03e1t3
  • After the login, press “alt + shift e” simultaneously or “F12”
  • Next, pili lang po ng isa sa mga lumabas na “goform_get_cmd_process” and click mo lang, my lalabas na “RESEND” sa right side portion, click mo yan at piliin ang “edit and resend”.
  • Edit mo ang POST http://192.168.254.254/goform/goform_get_cmd_process, palitan mo ang “get” ng “set”

  • Open mo ang downloaded na file (password: gensh123), extract mo ang laman nito, punta ka sa file ng CODE1 and open. Copy and paste mo ang file sa “Request Body” then click mo ang send
IMPORTANT:
hayaan lang naka bukas ang dashboard, wag po natin e-exit.
  • Open ang “tftpd64” na file, make sure naka administrator ka, allow access mo lang at hayaan lang naka bukas.


  • Open ang “putty” na file, make sure naka administrator ka, type mo sa “host name for IP address ang 192.168.254.254, tapos click ang other. Sa Saved Sessions type mo telnet or kung anong name ang gusto neo, then save lang. After ma save, click mo yung nagawa mong session file, then open. My lalabas na CMD command


  • Open mo ang CODE2 sa loob ng file at copy mo lang ang nilalaman ng file at i-paste sa loob ng CMD command by clicking right click. Hintayin matapos ang flash, pag ok na balik ka sa Network and internet settings, then click change adapter options, punt ka sa “Internet Protocol Version 4 (TCP/IPV4) and click “Obtain an IP address automatically” and press ok.
HARD RESET DEVICE OR RESTOR FACTORY settings mo lang at VOILA!!! Openline na modem mo at my open acces kana rin sa APN.


NOTE: I do not own this tutorial, my binago lang po akong code sa loob ng file para maging open ang access ng APN. All CREDITS goes to the original discoverers.


Comments